How a Japanese Watch Brand Cut Transit Damage with Die-Cut Cushion Pads
Customer: a Japanese watch distributor supplying retail counters and online orders.

Product used: Cushion Paper Pad, 80 gsm kraft, 12 layers, die-cut to the presentation box outline.
Result: transit damage claims down from 2.8% to 0.4% over two quarters.
The problem
The customer shipped presentation boxes inside a standard corrugated mailer. Inside the box, the watch sat in a moulded plastic blister that held the case but not the box. In transit the presentation box moved within the mailer, and damage appeared in two forms: crushed corners on the outer box, and scuffing on the lacquered lid where it rubbed against the mailer wall.
The plastic blister was doing its job. The problem was the gap between the blister and the mailer.
Adding loose void fill was tried first. It worked, but it added a packing step, the fill migrated, and the customer's retail partners complained about the material spilling out on opening.
The specification
We proposed a die-cut cushion pad that would sit around the presentation box like a sleeve with a base — a single 80 gsm kraft pad, 12 layers, cut to the box footprint plus a 3 mm offset, with two score lines allowing the pad to fold up the long sides.
| Parameter | Specification |
|---|---|
| Material | 80 gsm kraft paper |
| Layers | 12 (approximately 1.6 cm) |
| Size | Cut to presentation box footprint + 3 mm |
| Format | Flat pad with two score lines |
| Colour | White kraft to match the box interior |
| MOQ | 1,000 pieces per size |
The 12-layer build was chosen against a drop test rather than a formula. Six layers, our standard starting point at roughly 0.8 cm, was not enough: at a 1.2 m drop on the corner, the box still showed deformation. Twelve layers passed. Eighteen was tested and passed too, but added 4 mm of stack height to every retail box and gained nothing measurable.
What changed operationally
Packing time went from an average of 34 seconds per order to 41 seconds for the first month, then back to 33 seconds once operators learned to drop the box into the pre-formed pad rather than folding it around the box.
The material is supplied flat in bundles of 200. Storage footprint for a month of pads is roughly a third of what the loose fill occupied, because the pads are flat and uniform rather than a loose volume.
The result
Over two quarters the customer recorded 11 damage claims against approximately 2,750 shipments, down from a prior rate that produced 77 claims on a comparable volume. The retail partner complaints about loose fill stopped entirely.
The customer has since extended the same pad format to two additional box sizes, using a single die line with different score positions, which keeps the tooling cost to one plate.
What we would change next time
The first iteration was specified in brown kraft because that is our stock colour. The customer later moved to white to match the box interior, which required a separate production run and a longer first lead time. For presentation-critical packaging, specify the colour at the sample stage, not after approval.
Data note: figures in this article are representative values from this application type, shown for specification guidance. Project-specific data is available under NDA on request.